ACDelco 15771354 Hummer H2 Rear Passenger Side Window Regulator Assembly

You looking to find the "ACDelco 15771354 Hummer H2 Rear Passenger Side Window Regulator Assembly" Good news! You can purchase ACDelco 15771354 Hummer H2 Rear Passenger Side Window Regulator Assembly with secure price and compare to view update price on this product. And deals on this product is available only for limited time.

Price: $170.33    

Product Description

Window Reg With Motor

ACDelco 15771354 Hummer H2 Rear Passenger Side Window Regulator Assembly Review

I received the product from Amazon very well packed, The installation on my H2 HUMMER RT Rear Passenger Window Regulator was very straight forward and easy. The total time too install took 15 minutes and thats with removing the RT Rear door panel and a couple of hand tools required to complete the job,
1) 1/4 Racheet with 8" extension and a 10mm and 12mm socket.
2) Cross Point screw driver about 6" long
3) Duct Tape to hold the window up in the full closed position while the Window Regulator is being installed.

Remove your door panel and upper door plastic molding not attached to the door panel, the door panel will have one Phillips screw that will have to be removed to gain access to the inner door panel screws located behind the inside door handle "Screws 10mm"
After removing the Phillips screw and the two 10mm bolts you can now begain to remove the door panel by placing a butter knife between the door panle and the door frame working your way around the door while seperating door panel from frame being held in place by Plastic inserts.
Once door panel is free you must remove two electrical connections from door panel one for the Window Switch and the second for the door panel light.
Once removed you will have to gain access to the inner door frame by removing the plastic covering, with this step complete you will have to locate TWO Bolts that secure the lower window to the Regulator frame two bolts 12mm heads loosen and manually lift the window to the full Closed/Up position and apply Duct Tape from the inside of the window to over the top of the Window/Door frame and attaching it the the out side of the window this will allow the window to stay up and out of your way while you R&R the Window Regulator Frame, the New Window Ragulator will have all Hardwear required already mounted : )
Remove your Duct Tape and lower your window onto the New Window Regulator Frame just installed and secure the bolts that clamp the window onto the frame "CAUTION" DO NOT over tighten these bolts becuase you could Shatter the Window itself during this process "NOTE" these bolts only require 25inch lbs of torque which is nothing more than tight! secure all hardwear and run the window thru a couple of times before completing the rest of the work in reverse.
GOOD LUCK and I hope this Helps someone out there faced with the same project I was ; )
I saved a Buddle doing it myself and Thanks too Amazon and their availability!!

Most of the consumer Reviews tell that the "ACDelco 15771354 Hummer H2 Rear Passenger Side Window Regulator Assembly" are high quality item. You can read each testimony from consumers to find out cons and pros from ACDelco 15771354 Hummer H2 Rear Passenger Side Window Regulator Assembly ...